New 5 jet PMF Titanium Wand

[Loren Egland]

What do you think of the Joe Bristor set up with 5 jets on the new PMF Titanium wand?

 

[Bob Savage]

So, Loren, did you get that same email today?

 

[Guest]

I think it looks Awesome!! I'm looking into a Sears version with the Joe's 5 Jet sheer kit.

 

[Loren Egland]

So, Loren, did you get that same email today?

Yup

 

[KevinD]

?

 

[Lee Stockwell]

I'm sure we ALL got the email from Joe.

 

[Nate The Great]

I'm sure we ALL got the email from Joe.

I hate being on the outside looking in........ Am I glad to not be receiving emails from him?

 

[Mike Pailliotet]

Would you please forward me the email.

pailliotet@sbcglobal.net

 

[Steve Lawrence]

Looks a tad clunky but I haven't tried it. If it's jetted properly and is built to use a hole glide it might be a winner. I'll be following this closely.

 

[Jim Martin]

I should have one in my hands in about 2 weeks.......give me a bit of time to put it threw the paces and I will let you know.......

 

[Mike Pailliotet]

Are those removable metal lips or part of the head like Taf's Big Boy?

 

[Jim Martin]

I don't think they are removable....

 

[Mike Pailliotet]

Holey mother of gawd.


How could any Teflon Glide user even consider that bear trap?

 

[Jim Martin]

that thing hanging off the front edge kinda concerns me.......there are places that you can't go with the wall you have to go at it straight on...and that (what looks like a good inch to inch and a quarter) thing that is sticking out may leave to big of a gap when trying to edge.....I am also curious to see how hard it is going to lock down with a big blower...... It does have notches cut in the sides that will help relieve some of the pressure....But until I get it on the floor I don't know how it will do.........

 

[mwall2230]

The metal lips must be removable because he said that a teflon gide will cost you $100 more.

 

[Jim Martin]

The metal lips must be removable because he said that a teflon gide will cost you $100 more.

you may be correct.the picture I put up looks like a weld on the back..but I found a few more and it is not welded on.......

 

[Nate The Great]

20 degree angle on the jets. It reminds me of the hydrokinetic tool...

 

[Ron Werner]

the "ski" was supposed to help with pushing the wand. ACcording to Joe it still locks down.
Put a glide on it and will have to adjust that jet angle. Too thin an angle and the flushing isn't as good, too steep and its the same as the old wands.
Nice looking wand but I'll stick with my Greenhorn

 

[ACE]

20 degree? I bet it's worthless on high cut pile. I do like some of the cheep 2" PMF wands. who cares needs titanium with a green glide?

 

[Loren Egland]

What do you think of the 6 jet PMF Titanium wand, a Joe Bristor email? It looks like the spacing would be better. The two outside jets seem more likely to cover the whole wand path.